Fully 3d printed 1:10 RC drift chassis with front macpherson suspension. Realistic design and roll cage looks like a real car. This chassis has front motor configuration and rear wheel drive.

To build, in addition to printed parts, you will need: electronics, bearings, bolts, etc. A complete list of everything you need and assembly instructions can be found in the detailed manual.

Specifications:

• Chassis width - 190mm
• Frame width - 161mm
• Wheelbase - 257mm
• Gear ratio - 6.17

- bearing 8x12x3.5: 16pcs.
- MST 4.8x4.5 ball connector: 12pcs.
- MST 4.8 hex ball: 4pcs
- MST damper (57mm): 2pcs.
- Wheels (+5 offset)
- Body 190mm
- magnets 10x1: 8pcs.
for front struts (dampers):
- MST piston rod for FXX: 2pcs.
- o-ring P3: 2pcs.
- e-clip 2.0: 4pcs.

screws:
- button head M3x35: 2 pcs
- button head M3x20: 2 pcs.
- button head M3x10: 6 pcs.
- button head M3x8: 23 pcs
- button head M3x6: 36 pcs
- button head M3x5: 24 pcs
- flat head M3x16: 7 pcs.
- flat head M3x10: 16 pcs.
- flat head M3x8: 13 pcs.
- flat head M3x6: 8 pcs.

electronics:
- 540 motor
- ESC
- standard servo
- rc radio transmitter and receiver
- drift gyro
- 2S short Lipo battery
- battery charger

RC 1:10 Tube Drift chassis

RC 1:10 E30 Drift chassis

Sliced S1 1:10 RWD RC drift chassis

20$

20$

20$